SKU: 1204086
A set of 25mm diameter (ID) hardened steel dry vacuum pressing die set for pellet presses, ready for you to make 25mm diameter cylinder-shape pellets in a vacuum condition.
Specifications
Maximum Pressure: 30 tons
Rockwell Hardness: Rc 62
Diameter (ID): 25 mm
Height: 105 mm (assembled without sample)
Sleeve Height: 50 mm
Sleeve Diameter (OD): 46 mm
Tolerance: 0.01-0.02 mm (10-20 micron)
Material:Max sample fill height: Not to exceed 1/3 of the sleeve height
Core die & push rod: W18Cr4V hardened carbon tool steel
Sleeve, ejector & support: Cr12 hardened carbon mold steel
Die set includes
Two 25mm ID core dies made of highly polished hardened steel
One steel sleeve with vacuum connector
One steel support plate
One push rod
Rubber sealing o-rings
One steel cylinder pellet ejector
Important
Always wear protection goggles and gear during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 30 tons. Across International is not responsible for any damage caused by misuse.
Category: Pressing Dies / Vacuum Dies